Comnav 40350011 CT2 Drive Box PCB

Comnav 40350009 CT5 Drive Box PCB

Comnav 40350008 CT4 Drive Box PCB

Comnav 40350007 CT3 Drive Box PCB

Comnav 40350005 Z-Drive PCB ( Two Channel)

Comnav 40350004 Z-Drive PCB ( One Channel)

Description The CT7 Box designed to work with the ComNav Commander/Admiral Advanced Autopilot Systems. It is the interface between the Signal Processing Unit to Electric Wheel, Bow/Stern Thruster, Azimuth Drive, Surface Piercing Drives and Jet Drives. It...

Description The ComNav Z-Drive Isolation Amplifier module (one or two channel) provides total galvanic isolation between ComNav Autopilot systems and the electronics control systems typically found on Rudder/Propeller Z-Drive, Surface Piercing Drives...

Description The ComNav CT5 Drive Box is used to connect ComNav Autopilots to vessels using two speed (dual rate) DC solenoid valve systems. The CT5 is a recommended accessory for any Two-speed Uniblock manifolds steering system. The Drive Box will...

Description The ComNav CT4 is used in situations with the steering interface that has 115 or 220VAC solenoids. Highlights of the CT4 drive box include: Solid state circuitry Anodized aluminum housing (watertight if installed correctly) Uses...

Description ComNav CT3 Drive Box is specifically designed to connect ComNav autopilots to 3-wire split field DC motors. These motors are usually found on older reversing electric pump sets or mechanical drive autopilots. The box is transistorized ...

Description ComNav CT2 Drive Box is specifically designed to connect Comnav 1001,1101, 1201, and 2001 autopilots to steering systems using reversing DC Motor Pump sets, Linear actuators or DC Motor Mechanical Drive Units. The CT2 Motor Controller...