Part Number: 2774014

Old Part Numbers:  2324012, 2324017, 2324019, 2324023, 2774053

Minn Kota 24/36 Volt Terrova/ST Control Board Assembly

THIS CONTROL BOARD HAS BEEN DISCONTINUED AND IS NO LONGER AVAILABLE FROM MINN KOTA.  PLEASE CALL THE SHOP WITH THE SERIAL NUMBER OF YOUR TROLLING MOTOR, 715.546.2333, FOR OTHER OPTIONS.

Fits the following Minn Kota trolling motor models:

• Minn Kota Riptide Saltwater Terrova and RT/ST models from 2007 - 2016
• Minn Kota Terrova models from 2007 - 2016

Fits models with 80, 101 or 112 lbs of thrust

Some Minn Kota models contained a control board that was only equipped with one accessory plug (the plug with the yellow dot).  Although this control board has two accessory plugs, this control board is a direct replacement, but only one accessory plug will be used.

Serial Numbers will contain the following designations after the WW:

AH, AI

or start with the letters:

J, K, L, M, N, O, P, Q

***Note:  This control board is not compatible for Terrova BT or Riptide Terrova BT models built from 2017 to present that are equipped with Bluetooth.  The control board needed for these motors is part number 2774069.

If you have lost steering function, please read:

Terrova/ST motors use drive housings that are specific to the voltage of the motor.  For example, a Terrova 55/ST 55 uses a 12-volt drive housing, a Terrova 80/ST 80 uses a 24-volt drive housing, and a Terrova 101 & Terrova 112/ST 101 & ST 112 use a 36-volt drive housing. To properly test the drive housing apply the voltage appropriate for the model directly to the drive housing leads while observing the drive housing amp draw. The amp draw under bench test, no load, conditions should be less than 2 amps for a 12-volt drive housing, and less than 1.5 amps for 24-volt and 36-volt drive housings. (NOTE: Reverse the polarity at the drive housing leads to check amp draw in both clockwise and counterclockwise rotation.) If the drive housing amp draw exceeds the values listed (2 amps for 12-volt drive housings or 1.5 amps for 24-or 36-volt drive housings) suspect that the drive housing has taken out the steering circuit on the main control board.  (NOTE: When this has occurred the drive housing MUST be repaired or replaced prior to replacing the main board. If the higher than normal amp draw of the drive housing is not corrected the steering circuit on the new/replacement main control board will also fail.)

Not sure if this part will fit your Minn Kota trolling motor?  .