Part Number: 2774016

Old Part Numbers:  2324011, 2324013, 2324016, 2324018, 2324022, 2774052

Minn Kota 12 Volt Terrova/ST Control Board Assembly

Fits the following Minn Kota trolling motor models:

• Minn Kota Terrova 55 models from 2007 - 2016
• Minn Kota Riptide Saltwater Terrova and RT/ST 55 models from 2007 - 2016

Some Minn Kota models contained a control board that was only equipped with one accessory plug (the plug with the yellow dot).  This control board is a direct replacement, but only one accessory plug will be used.

Serial Numbers will contain the following designations after the WW:

AH, AI

or start with the letters:

J, K, L, M, N, O, P, Q

***Note:  This control board is not compatible for Terrova BT or Riptide Terrova BT models built from 2017 to present that are equipped with Bluetooth.  If you have a 2017 or newer model, please call the shop, 715.546.2333.

If your Terrova has lost steering function, please read:

Terrova/ST motors use drive housings that are specific to the voltage of the motor. For example, a Terrova 55/ST 55 uses a 12-volt drive housing, a Terrova 80/ST 80 uses a 24-volt drive housing, and a Terrova 101 & Terrova 112/ST 101 & ST 112 use a 36-volt drive housing. To properly test the drive housing apply the voltage appropriate for the model directly to the drive housing leads while observing the drive housing amp draw. The amp draw under bench test, no load, conditions should be less than 2 amps for a 12-volt drive housing, and less than 1.5 amps for 24-volt and 36-volt drive housings. (NOTE: Reverse the polarity at the drive housing leads to check amp draw in both clockwise and counterclockwise rotation.) If the drive housing amp draw exceeds the values listed (2 amps for 12-volt drive housings or 1.5 amps for 24-or 36-volt drive housings) suspect that the drive housing has taken out the steering circuit on the main control board. (NOTE: When this has occurred the drive housing MUST be repaired or replaced prior to replacing the main board. If the higher than normal amp draw of the drive housing is not corrected the steering circuit on the new/replacement main control board will also fail.)

Not sure if this part will fit your Minn Kota trolling motor?  .